PermitsHubPermitsHub

Do I Need a Permit?

Do You Need a Permit for a Fence on a Scarborough Bluffs or Ravine Lot?

Most Scarborough fences don't need a building permit, as long as they follow Toronto's height rules. Lots near the Bluffs, Highland Creek or any ravine are different. TRCA regulation, the City's ravine bylaw and tree protection rules can all apply to a fence, and corner lots on post-war bungalow streets carry their own sight line limits.

By PermitsHub Team9 min read

Key Takeaways

  • A standard Scarborough fence that meets Toronto Municipal Code Chapter 447 height limits doesn't need a building permit, but that rule only covers height and placement, not the ground the fence sits in.
  • On lots near the Bluffs, Highland Creek or a ravine, post holes, concrete footings, regrading and tree root damage can trigger TRCA review under Ontario Regulation 41/24, the City's Chapter 658 ravine bylaw, or a private tree permit.
  • Many Bluffs and ravine lots end before the visible yard does, so a current survey showing the property line and top of bank should come before any fence layout.
  • Corner lots on post-war bungalow streets have sight triangle limits and wide City boulevards, which are the two most common reasons a Scarborough fence gets an order to cut down or move.

Fences Above The Bluffs

For most Scarborough homes, no, you don't need a building permit for a fence. Toronto regulates fences through Municipal Code Chapter 447, and a fence that stays within its height limits (generally 1.2 metres in the front yard and 2.0 metres in the side and rear yards) can go up without any application. On a Scarborough Bluffs or ravine lot, though, the height rule is only one layer. If your property falls in a TRCA regulated area or the City's ravine protection area, digging post holes, pouring footings or regrading along the fence line can need approval even when the fence itself is perfectly legal in height.

What Chapter 447 covers on an ordinary Scarborough lot

Chapter 447 is a height and location bylaw. It doesn't care whether your fence is cedar, vinyl, composite or chain link. It cares how tall it is, measured from the ground at the fence, and which yard it sits in. Toronto doesn't issue a permit for a compliant fence, and there's no inspection. The only routine fence permit the City issues is for a pool enclosure, which has its own design rules for gates, climbability and latch height.

If you live on a flat interior lot in Agincourt, Wexford or Malvern, that's usually the whole story. Build within the height limits, keep it on your side of the line, and you're done. The trouble starts when the lot slopes, backs onto a valley, or sits on a corner.

Three approvals that can apply to a fence near the Bluffs or Highland Creek

Scarborough has more regulated land than most of Toronto. The Bluffs shoreline from Birch Cliff through Cliffcrest, Scarborough Village and Guildwood, plus the Highland Creek valley system running through West Hill, Morningside Park and Highland Creek itself, put thousands of backyards next to an erosion hazard or a valley corridor. Three separate rule sets can reach a fence on those lots.

TRCA under Ontario Regulation 41/24

The Toronto and Region Conservation Authority regulates development in hazard areas under Ontario Regulation 41/24, which replaced the older TRCA regulation in April 2024. The regulated area includes shoreline erosion hazards along the Bluffs, valley and stream corridors, and an allowance beyond them. Development under the regulation includes building structures, placing fill and altering grade. A fence is a structure, and concrete footings or a levelled fence line are grade changes. Some minor fence work gets confirmed quickly as acceptable or not needing a permit, but on a lot near the top of bank you shouldn't assume. The way to find out is to check TRCA's regulation mapping and, if you're inside it, send TRCA a property inquiry before the posts go in.

Toronto's Ravine and Natural Feature Protection bylaw

Municipal Code Chapter 658 covers land the City has mapped as ravine and natural feature protection area. Inside that area, injuring or removing trees, dumping fill and altering grade need a permit from Urban Forestry. A fence on its own isn't the issue. The issues are the auger cutting through roots, the excavated soil spread down the slope, and the small retaining edge someone adds so the panels sit level. Those are the details Urban Forestry looks at.

Private tree protection under Chapter 813

Even outside the ravine area, Toronto protects private trees of a certain trunk size, and digging within a protected tree's root zone can require a permit. Ravine lots tend to have big mature oaks, maples and white pines right along the back property line, which is exactly where the fence wants to go. Post holes can often be shifted or hand dug to avoid major roots, but that decision should happen on paper, not with the auger running.

On a Bluffs lot, the fence height is the easy part. The questions that stop jobs are where the posts sit relative to the top of bank, and who actually owns that last strip of grass.

How to tell whether your lot is caught before you order materials

Have a project in mind? Get an honest, no-pressure permit review from PermitsHub.

You can work out most of this yourself in an evening. Go through these checks in order, because each one changes what you do next.

  • Pull up TRCA's online regulation mapping and look for your lot. If any part of it is shaded, the fence location matters and a property inquiry is worth sending.
  • Check the City of Toronto's ravine and natural feature protection mapping on its interactive map. Rear lot lines along Highland Creek, Morningside Creek, Bendale and the Bluffs are commonly inside it.
  • Find your survey. If you don't have one, or it predates later erosion or land transfers, get an updated one. Many Bluffs lots end well before the edge of the lawn, with the remainder owned by the City or TRCA.
  • Walk the proposed fence line and note any tree with a trunk large enough to be protected, and any spot where you'd need to cut, fill or step the fence to keep it level.
  • Look at the slope itself. If the fence line is near a visible crest, near a drainage swale, or on ground that has slumped or cracked, stop and get advice before digging.

If all five come back clean, you're likely in ordinary Chapter 447 territory. If any of them raise a flag, it's far cheaper to sort out the approval first than to remove a finished fence later.

Corner lots on Scarborough's post-war bungalow streets

Large parts of Scarborough were built out in the 1950s and 1960s with bungalows on wide lots: Wexford, Dorset Park, Clairlea, Ionview, Bendale and much of Cliffcrest and Birch Cliff. Those subdivisions have a lot of corner lots, and corner lots are where fence complaints cluster.

Chapter 447 limits fence height near intersections so drivers can see cross traffic and pedestrians. The restricted area is a triangle measured back from where the two street lines meet, and inside it fences, screens and solid hedges have to stay low. A 2.0 metre privacy fence that's fine along the rest of the flanking side yard can be a violation where it reaches the corner. Confirm the exact triangle dimensions with Municipal Licensing and Standards before you finalize the layout, because the corner panels are usually the ones people want tallest.

The second corner lot problem is the boulevard. Scarborough streets often have wide City boulevards, so the grass you've mowed for twenty years may extend several metres past your actual property line. A fence built out to the sidewalk sits on City land, which needs encroachment approval under the City's streets bylaw and is frequently refused, especially near a corner. The fix is the same as on a ravine lot: locate the line from a survey, not from the edge of the sod.

What actually goes wrong on Bluffs and ravine fence jobs

Having worked on a lot of properties along the Bluffs and the Highland Creek valley, we see the same handful of problems over and over. None of them involve the fence being too tall.

  • The fence goes onto public land. A homeowner fences to the trees at the back, not knowing the City or TRCA owns the band of land between their yard and the crest. Encroachments onto ravine parkland get removal orders.
  • Concrete footings near the crest. A contractor pours full concrete footings in a row a short distance from the top of bank. On an eroding slope that's added weight and disturbed soil in exactly the wrong spot.
  • Grading to level the fence. The yard falls toward the ravine, so the installer cuts the high side and pushes fill down the low side. That's a grade alteration in a regulated area.
  • Clearing the slope for access. Brush and saplings along the bank get cut to make room for the crew. On a ravine lot, that vegetation is part of what holds the slope together, and its removal is regulated.
  • Redirected drainage. A solid board fence across a natural swale dams surface water and sends it around the ends, sometimes straight over the bank. TRCA and the City both care about that.

Neighbours notice these things. On the Bluffs especially, residents watch the crest closely, and a complaint about fill on the slope or a fence on City land brings an inspector out quickly.

When a fence project becomes a building permit

Have a project in mind? Get an honest, no-pressure permit review from PermitsHub.

A plain fence is not a building under the Ontario Building Code. A few common add-ons change that.

Retaining walls are the big one. The Building Code treats a retaining wall over 1 metre in height as a designated structure needing a permit when it's next to public property, a building access, or a private road or walkway. On sloped ravine lots, homeowners often want to build a low wall to create a flat strip for the fence, and that wall can cross the line into permit territory, plus engineering if the soil is anything other than ordinary.

Privacy screens on raised decks are the other. A deck more than 600 millimetres above grade needs a building permit, and any screen attached to it should be on those drawings. Because the screen sits on top of the deck, its height measured from the ground can be well above what Chapter 447 allows for a fence in the same spot. Have that question answered at the design stage. PermitsHub regularly draws deck permit sets for ravine lots where the screen, the footings near the slope and the TRCA review all have to line up in one submission.

Pool enclosures, as noted, always need their own City permit, and on a ravine lot the pool itself will likely need TRCA input before the enclosure is even discussed.

If you want a fence taller than the bylaw allows

Backyards facing a busy trail or a neighbour's raised deck often push owners toward something taller than 2.0 metres. Toronto handles that through a fence exemption application under Chapter 447, filed with Municipal Licensing and Standards and decided by the local Community Council, not the Committee of Adjustment. Expect neighbours to be notified, and expect the decision to weigh sight lines, the look from the street and, on ravine lots, the effect on the valley edge.

An exemption only deals with height. It doesn't clear the TRCA, ravine bylaw or tree permit questions, which still have to be answered separately. If you're asking for extra height on a Bluffs lot, sort out the regulated area issues first so Community Council isn't approving a fence that another authority later says can't go there. A site plan showing the survey line, top of bank, protected trees and proposed post locations answers most of those questions at once, and it's the kind of drawing PermitsHub prepares for exactly this situation.

Do I Need a Permit?

1
›
2
›
3
›
4

What are you planning to build or renovate?

Ready to move forward? PermitsHub handles permit drawings, submission, and revisions - flat-rate, GTA-wide.

Related Reading

More in this category

Do I Need a Permit?

FAQ

Related questions

Get started

Tell us about your project.

Free, no-pressure quote within one business day.

● Flat-rate quotes - no surprise fees

● Revisions included until approval

● Most enquiries responded to same day

Free Home Permit QuoteNo commitment · 30 sec
1
2
3

What are you building?

SCROLL TO SEE ALL 20 PERMIT TYPES

Prefer to call? 647-961-4070
CALL NOWFree Home Permit Quote30 SECONDS - NO COMMITMENT