By Area
Teardown and Rebuild in Don Mills (M3B): What Zoning Allows on 1950s Lots
Tearing down a 1950s Don Mills bungalow rarely gets you the giant box the lot size suggests. Lot coverage, a 19 metre building depth cap, side wall height rules, protected trees and West Don ravine limits all shape the footprint. Here is how those limits actually stack up on M3B, M3C and M3A lots, and where owners end up at the Committee of Adjustment.
Key Takeaways
- On most Don Mills and Parkwoods lots the new house is sized by lot coverage, not floor space index, so the footprint percentage on your zoning overlay is the first number to confirm.
- Shallow lots get squeezed from the back: the rear yard rule (the greater of 7.5 metres or 25 percent of lot depth) often limits you before the 19 metre building depth cap does.
- A single protected private tree of 30 centimetres diameter or more, on your lot or a neighbour's, can pull the footprint back further than any zoning setback, so the arborist report belongs at the start of design.
- Lots backing onto the West Don or East Don valleys may need TRCA permission and fall under the ravine bylaw, which can take part of a deep lot out of play entirely.
Rebuilding Don Mills Bungalows
On a typical 1950s Don Mills or Parkwoods lot, Toronto Zoning By-law 569-2013 usually allows a two-storey detached house whose footprint is capped by lot coverage (commonly in the 30 to 35 percent range in former North York), with a height limit that is often 10 metres, a maximum building depth of 19 metres, and a rear yard of at least 7.5 metres or 25 percent of lot depth, whichever is greater. The real size you can build is set by whichever of those limits bites first on your lot, and on these wide, shallow, tree-heavy properties it is often the rear yard, a protected tree or a ravine line, not the headline coverage number.
Why Don Mills lots don't behave like the rest of Toronto
Don Mills was planned from scratch in the early 1950s as a self-contained postwar community, with curving crescents, a mix of modernist bungalows, split-levels and two-storey homes, and generous green space threaded through the four quadrants around Don Mills Road and Lawrence Avenue. The lots reflect that plan. Many are wide at the street but not especially deep, and the ones on crescents and cul-de-sacs are irregular, pie-shaped or skewed. That geometry matters, because most zoning setbacks are measured from lot lines, and an odd lot line moves the buildable envelope in ways a quick glance at the frontage won't tell you.
The other defining feature is the canopy. Developers back then kept many existing trees and planted more, and seventy years later those trees are big, protected and frequently sitting right where an owner wants the new rear wall. Parkwoods (M3A) and the Don Mills pockets in M3C share the same pattern, with the added complication that a lot of rear lot lines drop toward the East Don or West Don valleys.
The zoning numbers that actually size your new house
Most residential lots here are zoned RD (Residential Detached) under 569-2013, often with a suffix for minimum frontage and area and sometimes an exception number pointing to site-specific rules. Pull your property up on the City's interactive zoning map before you look at a single floor plan. These are the standards our plan reviews check first on a Don Mills rebuild:
- Lot coverage: in much of former North York the RD zone is controlled by a lot coverage overlay rather than a floor space index, so your footprint is a fixed percentage of lot area. The percentage varies by street, so confirm it on the overlay map for your address.
- Height: set by the height overlay, commonly 10 metres for these streets, measured from established grade, which is the average grade at the front of the lot, not the lowest point at the back.
- Side main wall height: the side exterior main walls facing a side lot line are generally limited to 7.5 metres, which is what stops a flat-roofed three-storey box and pushes designs toward a sloped roof or a stepped upper floor.
- First floor height: the first floor generally can't sit more than 1.2 metres above established grade near the front, which limits how much you can raise the house to get a bright basement.
- Building depth: a detached house is generally capped at 19 metres deep, measured from the required front yard setback.
- Rear yard: the greater of 7.5 metres or 25 percent of lot depth.
- Front yard: usually tied to the average of the neighbouring houses, which on a street of setback bungalows can push you further back than you expected.
Here is a worked example to show how coverage translates into house size, using assumed numbers rather than any particular property. A 15 by 38 metre lot is 570 square metres. At 30 percent coverage, the footprint is roughly 171 square metres. Two full storeys over that footprint gives you somewhere around 340 square metres above grade, plus a full basement, before you subtract for the garage, open porches and any second floor setbacks you choose. That's a large house, but it is usually not the house an owner pictured after walking the 15 metre frontage.
Check for exceptions and the old North York bylaw
Some Don Mills properties carry site-specific exceptions in 569-2013, and a smaller number still have provisions carried over from former North York Zoning By-law 7625. An exception can tighten coverage, lock a setback or add a rule you won't find in the general RD text. Plan examiners at Toronto Building check both, so if your drawings comply with the general zone but miss an exception, you will get a zoning notice back and lose weeks.
Where shallow and crescent lots squeeze the footprint
Have a project in mind? Get an honest, no-pressure permit review from PermitsHub.
On a deep downtown lot, the 19 metre depth cap is usually what stops the house. On a shallow Don Mills lot, the rear yard often stops you first. Take a 35 metre deep lot: 25 percent is 8.75 metres, so the rear yard requirement beats the 7.5 metre minimum. Add a front setback averaged from bungalows that sit well back from the curb, and the strip left for the house can come in under 19 metres anyway. Owners then try to make it up in width, and side yard minimums plus coverage pull them back again.
Crescent lots create a different headache. When the front lot line is curved, the front yard average and the depth measurement both get interpretive, and a pie-shaped lot that widens toward the back gives you width exactly where the rear yard rule has already taken the land away. We see a lot of first concept plans on these lots that look fine in a sketch and fail on a proper survey overlay.
On a Don Mills crescent, the survey is the design. Draw the house before you have an accurate lot line and grade survey and you are designing a house for a lot that doesn't exist.
Trees often decide more than the zoning map
Toronto's Private Tree Bylaw (Municipal Code Chapter 813) protects private trees with a trunk diameter of 30 centimetres or more measured at 1.4 metres above grade, and City-owned street trees are protected regardless of size. In Don Mills, that describes a huge share of the mature maples, oaks and spruces on any given block. Removing or injuring one, including digging inside its root zone for a new foundation, needs a permit from Urban Forestry, and approval is not automatic.
The practical effect is that the tree protection zone, which the arborist report calculates from trunk diameter, becomes a no-dig area on your site plan. A large tree sitting 6 metres off the back of the old bungalow can hold your new rear wall right where the old one was, even though zoning would let you go deeper. Neighbours' trees count too: if their protected tree's root zone crosses the property line, you need to protect it, and you may need their consent to injure it.
Toronto Building treats tree protection as applicable law, so a demolition or building permit can sit waiting on Urban Forestry clearance. Get the arborist on site before design starts, and before winter if you can, because a leafless survey makes species identification and canopy mapping harder.
West Don and East Don ravine edges
Lots that back onto the West Don valley (the Edwards Gardens and Wilket Creek side) or the East Don through Parkwoods bring two more layers of control. The first is the Toronto and Region Conservation Authority, whose permitting now works under Ontario Regulation 41/24. If any part of your lot falls within a regulated area, typically defined around the top of bank, erosion hazard limits and floodplain, TRCA permission may be needed before Toronto Building will issue your permit. TRCA will often want the new house kept behind a setback from the stable top of slope, and a geotechnical slope stability study can be part of that conversation.
The second layer is the City's Ravine and Natural Feature Protection Bylaw (Chapter 658), which restricts tree removal, grading and fill placement inside the mapped ravine area. On some deep ravine lots, this means the back third of the property simply can't be used for house, pool or retaining walls, no matter what the zoning says. The good news is that a teardown on an existing footprint well back from the slope often clears TRCA with fewer conditions than owners fear, but you need the staking and the study to prove it.
As of right or Committee of Adjustment: how to decide
Have a project in mind? Get an honest, no-pressure permit review from PermitsHub.
Once the survey, arborist report and any TRCA limits are on paper, you have a real envelope. Then the decision is simple to frame, even if it isn't simple to make.
- Build as of right if a house that fits every standard gives you the rooms you need. You skip the hearing, the notice to neighbours and the risk of refusal, and you go straight to a building permit application.
- Apply for minor variances if you are a little over on coverage, side wall height, building depth or first floor height. These are the most common variances we see on North York teardowns and they go to the North York panel of the Committee of Adjustment.
- Rethink the design if you need several large variances at once. The panel tests each request against the four statutory tests under the Planning Act, including whether it maintains the intent of the Official Plan, whose Neighbourhoods policies ask new homes to respect and reinforce the existing physical character.
Don Mills neighbours are organized and they read hearing notices. A request that adds bulk at the side walls or puts tall windows over a neighbour's backyard draws written objections far more often than a request for a bit more coverage at the rear. In our experience on Don Mills and Parkwoods rebuilds, the applications that pass cleanly are the ones that keep the street-facing scale modest and put the extra floor area where neighbours can't see it. Committee timing is unpredictable, so confirm current hearing schedules with the City, and plan for the possibility of an appeal to the Ontario Land Tribunal if a neighbour objects strongly.
One more option worth weighing: Toronto now permits multiplexes of up to four units in residential neighbourhoods, plus garden suites in many backyards. Some Don Mills owners rebuild as a house with a secondary suite or a small multiplex. The same coverage, height and tree limits still apply, but the unit mix can change what makes sense to build inside that envelope.
The realistic sequence from bungalow to framing
Owners lose the most time by doing these steps out of order. The sequence that works on Don Mills lots looks like this:
- Order a topographic and boundary survey showing grades, trees, neighbouring house positions and the top of bank if you're near a valley.
- Commission an arborist report and, on ravine lots, contact TRCA early to confirm whether your lot is regulated.
- Get a zoning review against 569-2013 and any site-specific exception before concept design is final.
- Design the house, then file the Committee of Adjustment application if variances are needed.
- Apply for the demolition and building permits together where possible, with tree permits, TRCA permission and any variance decision in hand.
- Disconnect utilities, demolish, install tree protection hoarding, and book the first inspections.
PermitsHub prepares the permit drawings, zoning review and submission package for teardown rebuilds across North York, and handles the examiner's revision requests when they come back. Whoever you work with, insist on the survey and arborist report before anyone shows you elevations. On a 1950s Don Mills lot, those two documents tell you how big the house really is.
Do I Need a Permit?
What are you planning to build or renovate?
Ready to move forward? PermitsHub handles permit drawings, submission, and revisions - flat-rate, GTA-wide.