PermitsHubPermitsHub

By Area

Rear Addition on a Cedarvale Ravine Lot in Humewood-Cedarvale (M6C)

Backing onto Cedarvale Ravine is the reason you bought the house, and it is also the reason your rear addition needs approvals most Toronto homeowners never hear about. Here is the order they come in, what the City and TRCA actually look at, and why so many Humewood and Forest Hill additions end up at Committee of Adjustment before a building permit is ever issued.

By PermitsHub Team9 min read

Key Takeaways

  • Most Cedarvale Ravine lots can take a rear addition, but the building permit comes last, after ravine protection, tree and possibly TRCA clearances are in hand.
  • The physical top of bank, staked on site and confirmed by City or TRCA staff, usually decides how far back you can build, so get it staked before you finalize a design.
  • An arborist report that covers your trees, your neighbours' trees and City trees is almost always required, and foundations inside a tree protection zone often have to switch to piles or caissons.
  • Large Humewood and Forest Hill houses frequently exceed the 17 metre building depth limit once an addition goes on, which adds a Committee of Adjustment hearing where Urban Forestry and TRCA also comment.

Building Beside Cedarvale Ravine

Yes, you can build a rear addition on most lots backing onto Cedarvale Ravine, but the building permit is the last approval you get, not the first. Before Toronto Building will issue, a ravine lot in Humewood-Cedarvale or Forest Hill usually needs clearance under the City's Ravine and Natural Feature Protection by-law (Municipal Code Chapter 658), a review of protected trees under the tree by-law (Chapter 813), and, if the property falls inside the Toronto and Region Conservation Authority's regulated area, a TRCA permit or written clearance. If the addition pushes the house past the zoning by-law's building depth limit, a Committee of Adjustment variance gets added on top.

The sequence matters more than any single approval. Homeowners who hire a designer, draw a beautiful two-storey addition and then go looking for approvals are the ones who end up redrawing it twice. On a ravine lot, the site tells you what you can build. The drawings come after.

First, Confirm Which Ravine Rules Actually Touch Your Lot

Not every house on Glen Cedar Road or Ava Road is regulated in the same way, and two neighbours can face very different requirements depending on how far their rear lot line sits from the slope. Before anything else, check three separate maps, because each one triggers a different approval.

  • The City's Ravine and Natural Feature Protection mapping, which shows whether any part of your lot falls inside the Chapter 658 protected area. If it does, grading, fill, tree removal or injury and construction activity in that area need Urban Forestry's sign-off.
  • TRCA's regulated area mapping under Ontario Regulation 41/24, which covers valley and stream corridors plus an allowance beyond them. If your addition, or even your excavation and stockpiling, lands in the regulated area, TRCA has to review it.
  • The zoning map for Zoning By-law 569-2013, which tells you your zone, your building depth limit and whether any site-specific exceptions apply. A small number of properties are still governed by former by-laws, so confirm which one applies before you count metres.

If the City's ravine protection line clips the back third of your yard but your addition stops well short of it, your review may be fairly light. If the line runs right through where you want the new family room, expect the full process described below.

The Order Approvals Come In on a Cedarvale Ravine Lot

Here is the sequence we see work on Humewood and Forest Hill ravine lots. Some steps overlap, but trying to skip ahead almost always costs more time than it saves.

Step 1: Survey and top-of-bank staking

You need a current topographic survey prepared by an Ontario Land Surveyor showing grades, trees, the existing house and the slope. Where the ravine is close, City or TRCA staff typically attend the site to confirm the physical top of bank, and the surveyor then locates those stakes on the survey. This line becomes the reference point for every setback that follows. Cedarvale's slopes are steep and wooded in many places, and the top of bank is rarely where homeowners assume it is. It is often closer to the house than the fence line suggests.

On a ravine lot, the line that decides your addition is drawn by a surveyor standing in your backyard, not by a designer sitting at a desk.

Step 2: Slope stability and geotechnical review

If the addition approaches the slope, TRCA and the City will usually want a geotechnical slope stability assessment that establishes the long-term stable top of slope. That line accounts for future erosion and can sit further from the ravine than the physical bank. TRCA's policies generally expect development to stay back from it by a buffer, often 10 metres, but confirm the exact requirement for your lot with TRCA staff because site conditions and existing development patterns can change the answer. Older Cedarvale houses were often built closer to the slope than today's rules would allow, which is why an addition that simply continues the existing rear wall can still get pushback.

Step 3: Arborist report and tree permits

An ISA-certified arborist inventories every tree that could be affected: yours, your neighbours' trees near the shared lot lines, and City-owned trees. Each tree gets a tree protection zone based on its trunk diameter under the City's construction-near-trees specifications. Anything that injures or removes a protected tree needs a permit, and inside the ravine protection area the bar is higher because the trees are holding the slope together. Expect Urban Forestry to require tree protection hoarding and, in many cases, financial security held until the work is finished.

Step 4: Zoning review, then Committee of Adjustment if needed

Once the buildable envelope is known, the design gets checked against zoning. If it complies, you go straight to the permit application. If it does not, you file a minor variance application with the Committee of Adjustment, and Urban Forestry and TRCA are circulated for comment. Their comments can become conditions of approval, so a variance granted with conditions is not the finish line.

Step 5: Building permit application

Toronto Building runs an applicable law review before it issues. That review is where an application stalls if the ravine clearance, tree permit or TRCA approval is missing. The structural drawings, the grading and drainage plan and the tree protection plan all have to agree with what the other agencies approved.

Why Big Forest Hill and Humewood Houses Hit the Building Depth Limit

Have a project in mind? Get an honest, no-pressure permit review from PermitsHub.

Many residential zones under By-law 569-2013 cap building depth at 17 metres, measured from the minimum required front yard setback. A lot of the houses in M5P and the larger Humewood properties were built deep to begin with, and some have already been extended once, often with a 1970s or 1980s sunroom or kitchen bump-out. Add a modern rear addition and the house is past the limit before you have finished sketching.

Building depth is not the only trigger. On ravine lots, the ground falls away toward the rear, so the back of a new addition can sit high above grade even when the front of the house looks modest. That can raise questions about main wall height, the height of rear decks and platforms, and how established grade is calculated. Floor space index and side yard setbacks can also come into play on wider additions. A good zoning review identifies every variance at once so you file a single, complete Committee application instead of discovering a second problem at the permit stage.

At the hearing, neighbours on ravine streets tend to focus on two things: loss of trees and how the addition looks from the ravine trail. Cedarvale is heavily used by walkers, and a tall, glassy rear wall that is plainly visible from the path draws more attention than you might expect. Showing the Committee that you have kept the mature trees and set the addition back from the slope does more for your application than any rendering.

What Plan Examiners and City Staff Send Back on Ravine Additions

Most delays on these projects come from the same handful of issues. Knowing them in advance is the cheapest way to avoid a second or third round of revisions.

  • Strip footings drawn straight through a tree protection zone. Urban Forestry will not accept trenching through the root zone of a protected tree, so the structural design often has to switch to helical piles or caissons with a grade beam.
  • Downspouts, sump pump discharge or a new walkout drain pointed toward the slope. Concentrated water running toward the ravine is an erosion risk, and staff will ask for it to be redirected or dispersed.
  • No construction access or staging plan. Excavated soil, bins and material piles cannot go in the ravine protection area or the tree protection zones, and on a narrow Humewood lot that takes real planning.
  • Grading changes not shown on the drawings. Even modest fill to level a patio beside the addition can trigger Chapter 658, so existing and proposed grades need to be clear.
  • Drawings that do not match the approved site plan. If TRCA or Urban Forestry approved a footprint, the permit set has to show exactly that footprint, not a slightly bigger version.

This is where PermitsHub spends a lot of its time on ravine files: coordinating the surveyor's top-of-bank line, the arborist's protection zones and the engineer's foundation design so the permit drawings tell one consistent story to every reviewer.

Design Choices That Keep a Ravine Addition Moving

The additions that get through fastest in Cedarvale tend to share a few traits. They grow up rather than out, adding a second storey over an existing rear portion or a modest footprint instead of reaching toward the slope. They keep the new rear wall at or behind the existing one where the ravine is close. And they treat the mature trees as fixed points in the design rather than obstacles to negotiate away.

A two-storey addition with a smaller footprint often costs less in ravine and tree approvals than a sprawling single-storey one, even though the construction itself is more involved. It also tends to stay inside building depth, which can remove the Committee of Adjustment step entirely. If you are weighing those two options, it is worth getting a zoning and site review first, because the right answer depends heavily on where your top of bank and your largest trees sit.

Walkout basements are popular on these lots because the grade drop gives you natural light at the lower level. Just keep in mind that a deeper excavation near the slope draws more geotechnical scrutiny, and the patio outside the walkout is part of the grading conversation.

A Realistic Timeline From First Survey to Permit in Hand

Have a project in mind? Get an honest, no-pressure permit review from PermitsHub.

Ravine additions take meaningfully longer to approve than an ordinary Toronto rear addition, and the reviews depend on each other in a chain. Staking has to be scheduled with staff, and geotechnical and arborist work cannot be finalized until the top of bank is fixed. Urban Forestry and TRCA review on their own timelines, and the Committee of Adjustment adds several months of its own if you need a variance. The building permit review itself is usually the shortest part, as long as everything before it is complete.

If you want to build in a particular spring or summer, work backwards and start the site work the previous year. Tree protection rules can also affect timing: some work near trees is better done at particular times of year, and the City has its own requirements around nesting season for tree removals. Ask your arborist early so the schedule is not a surprise.

We have worked on additions along the Cedarvale and Nordheimer ravines on both the Humewood and Forest Hill sides, and the projects that run smoothest are the ones where the homeowner accepted early on that the ravine sets the limits. Commission the survey and staking first, get an honest read on the buildable envelope, then design inside it. That order turns a frustrating year of revisions into a predictable process.

Do I Need a Permit?

1
›
2
›
3
›
4

What are you planning to build or renovate?

Ready to move forward? PermitsHub handles permit drawings, submission, and revisions - flat-rate, GTA-wide.

Related Reading

More in this category

By Area

FAQ

Related questions

Get started

Tell us about your project.

Free, no-pressure quote within one business day.

● Flat-rate quotes - no surprise fees

● Revisions included until approval

● Most enquiries responded to same day

Free Home Permit QuoteNo commitment · 30 sec
1
2
3

What are you building?

SCROLL TO SEE ALL 20 PERMIT TYPES

Prefer to call? 647-961-4070
CALL NOWFree Home Permit Quote30 SECONDS - NO COMMITMENT