PermitsHubPermitsHub

By Area

Privacy Fence and Screen Height Rules in East York M4C and M4J

On a narrow East York lot, a backyard privacy fence can usually go to 2.0 metres without any City approval. Anything taller, anything in a front yard over 1.2 metres, or anything in a corner sight triangle needs a fence exemption. Here's how the rules land on 1940s bungalow lots with mutual driveways and tight side yards, and what to check before you dig the first post hole.

By PermitsHub Team9 min read

Key Takeaways

  • Under Toronto Municipal Code Chapter 447, a residential fence in a rear or side yard can generally be up to 2.0 metres tall and a front yard fence up to 1.2 metres, with no permit needed if you stay within those limits.
  • Lattice toppers, privacy screens bolted to the fence and decorative caps all count toward the measured height, so a 1.8 metre fence with a 0.3 metre lattice top is over the limit.
  • Corner lots in East York carry sight triangle restrictions near the intersection that can cap a fence far below 2.0 metres, and the exemption process rarely overrides a traffic safety concern.
  • Going taller than the bylaw allows means applying to Municipal Licensing and Standards for a fence exemption, which involves neighbour notice and a decision that can take months, so plan it before the contractor is booked.

East York Fence Heights

In East York, a backyard privacy fence can generally be up to 2.0 metres tall in the rear and side yards, and up to 1.2 metres in the front yard, without any City approval. Those limits come from Toronto Municipal Code Chapter 447 (Fences). If you want something taller, or you want a solid fence where the bylaw restricts height near a corner, you need a fence exemption from the City, which goes through Municipal Licensing and Standards and is decided by Toronto and East York Community Council.

That's the short answer. The longer answer matters more in M4C and M4J than in most of the city, because the lots here make simple fence projects complicated. A wide suburban lot in Etobicoke has room for error. A 25 or 30 foot East York lot with a shared driveway, a detached garage at the back and a neighbour's kitchen window 1.2 metres from the property line does not.

What Chapter 447 actually allows on a typical East York lot

Chapter 447 splits your property into zones, and the height limit depends on where the fence sits, not what it's made of. The front yard is the strip between the house and the street. The rear yard is behind the back wall. Side yards are the gaps beside the house. On most East York streets off Cosburn, Mortimer, Woodbine and Pape, that side yard is narrow enough that you can touch both houses with your arms out.

  • Rear yard: generally up to 2.0 metres, which is the height most people mean when they say privacy fence.
  • Side yard: generally up to 2.0 metres, but where the side yard runs forward past the front wall of the house, the front yard limit takes over.
  • Front yard: generally up to 1.2 metres, which is enough for a picket or low decorative fence but not for screening.
  • Corner lots: the side facing the second street and the area near the intersection have their own rules, covered below.

Height is measured from the ground at the fence line to the top of the highest element. That sounds obvious until you're on a sloped lot. Many streets that drop toward the Taylor Creek ravine have backyards that fall away, and a fence that's 2.0 metres at the high post can easily read 2.3 metres at the low end. Stepping the panels so each section stays within the limit is the normal fix. If your fence sits on top of a retaining wall, how the City measures it depends on the specific condition, so confirm with Municipal Licensing and Standards before you build rather than after a complaint.

Mutual driveways: the fence you may be allowed to build but probably shouldn't

A lot of East York bungalows were built in pairs with a single shared driveway running down the property line to two garages at the back. The property line usually runs right down the middle of the asphalt, and each owner has a right-of-way over the other's half. That right-of-way is typically registered on title.

Chapter 447 is a height bylaw. It doesn't settle who owns what or who has the right to drive over it. You might be able to build a 2.0 metre fence down the centreline of a mutual driveway without breaking any fence height rule, and still be blocking your neighbour's registered access to their garage. That's a civil problem, not a City problem, and it tends to end with lawyers rather than inspectors.

The fence bylaw tells you how tall you can build. Your title tells you whether you can build there at all, and on an East York mutual driveway those are two very different answers.

The practical move on a mutual driveway lot is to pull your title and survey first, and to treat the fence as starting where the shared driveway ends, usually around the back corner of the houses. Privacy in the rear yard is what most people actually want anyway. Fencing the driveway itself rarely achieves it and almost always creates a dispute.

Corner lots and the sight triangle problem

Have a project in mind? Get an honest, no-pressure permit review from PermitsHub.

Corner lots are common in M4C and M4J because the street grid is tight and the blocks are short. They're also where we see the most fence complaints. Your rear yard on a corner lot often runs alongside the flanking street, so the fence you think of as a backyard fence is also a streetscape fence that every driver turning the corner sees.

Near the intersection, Toronto restricts fence height within a sight triangle, an area measured back from the corner along both property lines. The purpose is simple: a driver needs to see a kid on a bike coming down the sidewalk. A solid fence or dense screen in that triangle is the kind of thing a neighbour reports, and it's also the kind of thing staff are least willing to approve through an exemption. The exact dimensions of the triangle and the permitted height within it are set out in the bylaw, so measure your specific corner against the current text or have someone check it before you order materials.

Where corner lot owners usually get caught

  • Running a 2.0 metre fence all the way to the corner because the old chain link fence went there.
  • Treating the flanking side yard like an interior side yard when the bylaw treats it differently.
  • Planting cedars or installing a screen in the triangle and assuming only fences are regulated.
  • Building on what they think is their line when the boulevard is actually City property.

That last point matters on older streets. The grass strip between the sidewalk and many East York houses often belongs to the City, not the homeowner. A fence built on City boulevard needs separate permission from Transportation Services, and without it you can be ordered to remove it regardless of height.

Lattice toppers, deck screens and everything else that counts toward height

The most common way people end up over the limit isn't the fence itself. It's what gets added later. A 1.8 metre board fence with a 0.3 metre lattice topper is a 2.1 metre fence. Post caps that stick up above the panels count. A row of planter boxes mounted on top of the fence counts. Plastic privacy slats woven into an existing chain link fence don't change the height, but extending the posts to hang them higher does.

Privacy screens on decks are their own category. On a typical East York bungalow the back door sits several steps up from the yard, so the deck platform is well above grade before you add a single board of screening. A screen attached to a deck is generally treated as part of that structure, and Toronto requires a building permit for decks more than 0.6 metres above grade. Zoning By-law 569-2013 also controls how high and how close to the lot lines platforms and attached structures can be. A 1.8 metre screen on a deck that's already a metre off the ground is a very different thing from a 1.8 metre fence at grade, and the plan examiner will look at it that way.

This is where we see corrections come back on deck permit applications: the drawings show a clean platform, then a screen gets added in the field and the inspector flags it at final. If you want a screen, put it on the drawings from the start. When PermitsHub prepares deck drawings, we show the screen height and location relative to the side lot line so it gets reviewed once, not argued about at inspection.

Going taller: how the fence exemption process works

If 2.0 metres isn't enough, maybe because your neighbour's house sits higher than yours or there's a second-storey window looking straight into your yard, you can apply for a fence exemption. The application goes to Municipal Licensing and Standards, not Toronto Building, and you don't get a building permit at the end of it. You get a decision allowing a specific fence, at a specific height, in a specific location.

  • You submit an application with a site plan showing the fence location, height and materials, along with photos of the existing condition.
  • There's an application fee, which you should confirm with the City since it changes.
  • Abutting neighbours are notified and can comment or object.
  • City staff review it and prepare a recommendation.
  • Toronto and East York Community Council makes the decision, and the meeting is public.

The applications that succeed usually have a clear, specific reason tied to the site: a grade difference between the lots, an overlook problem from a neighbour's deck, a laneway or commercial use behind the property. Applications that just say you want more privacy are weaker. A letter of support from the affected neighbour helps more than almost anything else, and an objection from that same neighbour hurts more than almost anything else.

Timing is the part people underestimate. Between staff review and getting onto a Community Council agenda, it can take months. If you're planning a spring build, start the exemption over the winter. Building first and applying afterwards does happen, but if the exemption is refused you're the one cutting the fence down.

Ravines, trees and the other approvals a simple fence can trigger

Have a project in mind? Get an honest, no-pressure permit review from PermitsHub.

Parts of M4C and M4J back onto the Taylor Creek and Taylor-Massey Creek ravine system. If your rear lot line touches the ravine, your fence may fall under Toronto's Ravine and Natural Feature Protection bylaw, and in some locations the Toronto and Region Conservation Authority regulates development near the slope. A fence near a valley edge isn't always a quick weekend job, so check whether your property is mapped before you start.

Trees are the other one. Toronto's private tree bylaw protects trees with a trunk diameter of 30 centimetres or more measured at 1.4 metres above ground, and injuring the roots counts. Post holes dug with an auger right beside a mature maple or a neighbour's large tree can count as injury. City-owned street trees are protected regardless of size. If there's a big tree near your fence line, plan post spacing around the root zone, or get guidance from Urban Forestry before you dig.

A sensible order of operations before the first post goes in

Having worked on a lot of East York bungalow lots between Danforth and O'Connor, we've found that fence problems almost always trace back to doing things out of order. The sequence that avoids trouble looks like this:

  • Find your survey and check title for any right-of-way over a mutual driveway.
  • Confirm where the lot line actually is, especially at the front where the City boulevard may start.
  • Check whether you're on a corner lot and measure the sight triangle area.
  • Look for protected trees near the fence line and ravine mapping at the rear.
  • Decide your heights zone by zone, including any lattice or screen on top.
  • Talk to the neighbour on the shared line before you finalize anything.
  • If you need more than the bylaw allows, apply for the exemption before booking the contractor.

None of this needs to be complicated. Most East York fences go up legally with no City paperwork at all. The ones that turn into orders, complaints or Community Council hearings are almost always the ones where someone skipped one of those checks because the job seemed too small to bother.

Do I Need a Permit?

1
›
2
›
3
›
4

What are you planning to build or renovate?

Ready to move forward? PermitsHub handles permit drawings, submission, and revisions - flat-rate, GTA-wide.

Related Reading

More in this category

By Area

FAQ

Related questions

Get started

Tell us about your project.

Free, no-pressure quote within one business day.

● Flat-rate quotes - no surprise fees

● Revisions included until approval

● Most enquiries responded to same day

Free Home Permit QuoteNo commitment · 30 sec
1
2
3

What are you building?

SCROLL TO SEE ALL 20 PERMIT TYPES

Prefer to call? 647-961-4070
CALL NOWFree Home Permit Quote30 SECONDS - NO COMMITMENT